Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

lots of static....

Hi all,

do you think i can do a stuff like that with FWSM:

static (inside,outside) tcp 192.168.0.1 2020 192.168.0.1 2020 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 3030 192.168.0.1 3030 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 4040 192.168.0.1 4040 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 5050 10.1.1.1 5050 netmask 255.255.255.255 0 0

first 3 static with no_real_nat same address same port, 4 static real nat, outside same ip address then first 3 static inside another mapping.

thk

Das

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: lots of static....

Das,

Yes, this should be possible on the FWSM. Loaded the above configuration on a FWSM and it took it without any issue.

static (inside,outside) tcp 192.168.0.1 2020 192.168.0.1 2020 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 3030 192.168.0.1 3030 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 4040 192.168.0.1 4040 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 5050 10.1.1.1 5050 netmask 255.255.255.255 0 0

Regards,

Arul

*Pls rate if it helps*

2 REPLIES
Cisco Employee

Re: lots of static....

Das,

Yes, this should be possible on the FWSM. Loaded the above configuration on a FWSM and it took it without any issue.

static (inside,outside) tcp 192.168.0.1 2020 192.168.0.1 2020 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 3030 192.168.0.1 3030 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 4040 192.168.0.1 4040 netmask 255.255.255.255 0 0

static (inside,outside) tcp 192.168.0.1 5050 10.1.1.1 5050 netmask 255.255.255.255 0 0

Regards,

Arul

*Pls rate if it helps*

Community Member

Re: lots of static....

of course i'll rate :)

BR

Das

347
Views
0
Helpful
2
Replies
CreatePlease to create content