04-28-2009 06:32 AM - edited 03-11-2019 08:24 AM
Hi,
I've configured a active/passive cluster with a couple of 5520s. When making changes to the cluster, I don't worry about primary/secondary or active/standby, I simply use the ip address of the active ASA.
Is this ok/normal/best practice? Does it matter that right now I'm logging into the secondary - active ASA to make changes?
Thanks!
04-28-2009 11:58 AM
Make changes to the primary device and you'll be OK. Actually you'll get an error if you're on the back up device and you try and make a change.
ASA# config t
**** WARNING ****
Configuration Replication is NOT performed from Standby unit to Active unit.
Configurations are no longer synchronized.
ASA(config)#
Hope that helps.
04-28-2009 12:13 PM
It helps! Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: