05-28-2015 11:46 AM - edited 03-11-2019 11:00 PM
Hi all;
I am asking about the Failover (Active/Active) on asa 5525-x SFR.
I am configuring Failover(Active/Active), and make sure that the configuration of the failover is correct, between the tow appliances.
But when issuing the command failover on the secondary appliance, the failover failed and not activated and the following messages appear:
"Detected an Active mate"
"Mate NOT PRESENT card in slot 3 is different from mine SFR5525"
I have been checked the compliance between tow appliances and make sure that they have the same hardware and software specs.
they have "asa922-4-smp-k8.bin" image on both.
but the only differences that i have and do not know if that affect are:
(Secondary) show inventory: PID: ASA5525 , VID: V01
(Primery) show inventory: PID: ASA5525 , VID: V03
please note that the Firepower services on both appliances doesn't activated as there is no need right now, but the image : "asasfr-5500x-boot-5.3.1-152.img"
is already installed on both appliances.
any advice please
Thanks
Solved! Go to Solution.
05-28-2015 02:17 PM
Hello laith,
As you can see on that log, one of them has a module on slot 3.
Could you use the command show module on both units and see if both has the same module?
Regards.
06-01-2015 05:28 AM
Cool.
If you think the answer was helpful, please mark it as correct.
Regards.
05-28-2015 02:17 PM
Hello laith,
As you can see on that log, one of them has a module on slot 3.
Could you use the command show module on both units and see if both has the same module?
Regards.
05-31-2015 04:05 AM
Hello Andre;
Thanks for your reply. I have checked the software module and it was need a recovery.
So i issue the recovery commands for the SFR module.
It is done.
Regards
06-01-2015 05:28 AM
Cool.
If you think the answer was helpful, please mark it as correct.
Regards.
05-19-2017 07:21 PM
Hello
i ran into the same problem as well but I don't see the resolution on this thread. Can you please advise on the resolution for
mate not present card in slot 3 is different from mine sfr5525
05-19-2017 08:42 PM
Answered in this thread:
https://supportforums.cisco.com/discussion/13299321/ha-failure-due-mate-not-present-card-slot-3-different-mine-sfr5525
10-19-2017 03:54 PM
I got the same error: Mate NOT PRESENT card in slot 3 is different from mine SFR5515
I tried the command no monitor-interface service module with no success
The failover worked when I unistalled both sfr module and shutdown both sfr modules
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: