Migrate from PIX to ASA, problems with intermediate config from pixtoasa.ex
I have just started the process with migrating from PIX to ASA-platform. I have used to pixtoasa.exe-tool several times to convert my existing PIX-config to ASA 5520-config, this has been working ok. But after the last time I reset the ASA to factory-default it will not accept the intermediate config from pixtoasa.exe anymore. I am doing as follows:
1: Running the tool with the PIX-config as input, no erros occurs during this process.
2: Copy the output to the ASA via TFTP
3: Copy the file into startup-config
During boot the ASA shows a lot of errors, it seems the it does not accept the syntax of the PIX-commands, i.e. VPNGROUP-commands, that should be converted during boot. Any tips on thiswould be great. Do I have have set the ASA into a special mode to force it to convert the config? Thanks!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...