Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Migration ASA 8.6.1.10 to 9.0.2

My question is:

are there any specfic migration paths from ASA release 8.6 to 9.0

I have observed that no migration is done for the object ANY to ANY4

I have observerd that migration is done from ASA 8.4.6 to 9.0        

Everyone's tags (5)
3 REPLIES
Super Bronze

Migration ASA 8.6.1.10 to 9.0.2

Hi,

To my understanding the 8.6 software level is basically the starting software level of the new ASA5500-X series

I guess you could consider 8.3 or 8.4 the first new softwares of the original ASA5500 series.

With that being said it would seem to me that if you have an ASA5500-X series device that there is not really any software jump you can do from 8.6 other than to 9.0 or 9.1 series software.

I have mostly switched between 8.x and 9.x software on my test ASAs and have not faced any problems so far.

It would seem strange to me that no ACL migration would be done from 8.6 to 9.0? The Release notes does suggest that this should happen. i do have a new ASA5515-X but havent had the time to test it much yet.

- Jouni

New Member

Migration ASA 8.6.1.10 to 9.0.2

I have done an ASA 5585-x migration from 8.4.6 code to 9.0.2 with the migration for the ANY onject done automatically.

All new other X-Series ASAs start with 8.6

New Member

Migration ASA 8.6.1.10 to 9.0.2

problem is resolved in ASA 9.0.3

294
Views
0
Helpful
3
Replies
CreatePlease to create content