Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Missing Interface

I'm starting to configure my new ASA5510. Even though there are 4 Ethernet0 ports in back (Ethernet0/0 through Ethernet0/3), in ASDM, Configuration, Interfaces, I only see Ethernet0/0 through Ethernet0/2 and Management0/0. It does not allow me to add another port.

Where is my fourth Ethernet0 port?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Missing Interface

1 REPLY

Re: Missing Interface

116
Views
0
Helpful
1
Replies
CreatePlease to create content