Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Monitor IPSec tunnels in PIX

Hi Team,

I have PIX Version 6.3(5) configured with few IPSec tunnels. I would like to monitor these tunnels through snmp so that the PIX can send the trap notifying my monitoring tool if any IPSec tunnel goes down. I find the only command available is "snmp-server enable traps". Does this command event send traps for IPSec? Or if there is any alternate command, kindly suggest. Appreciate your response. Thanks!

Regards,

Manoj

1 REPLY

Re: Monitor IPSec tunnels in PIX

I am not sure about PIX version 6.3(5) but PIX version 7.0 supports the CISCO-IPSEC-FLOW-MONITOR-MIB and can send

cipSecTunnelStart and cipSecTunnelStop SNMP traps.

Syed Iftekhar Ahmed

217
Views
0
Helpful
1
Replies