Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Multicast around a multi-context FWSM

FWSM multi-context doesn't do multicast. So I'm attempting to doit the same way as you'd configure non-ip protocols like decnet.

I have put a vlan interface into the vlan, but with an unnumbered ip address

e.g.

interface vlan123

ip unnumbered loopback 0

and the normal IP route TO vlan123 is via the FWSM (In the same chassis).

Multicast is working fine from the core networks TO the vlan, I can see packets arriving at the hosts. But packets TO the group address FROM hosts on vlan123 get dropped at the router, with 'not RPF interface'.

Now I should eb able to override that with a static mroute... But I can't get a static mroute to behave as an INTERFACE route. It always wants a REMOTE IP address to uise as the neighbour.

Is there a better way? (I was thinking of using a VRF and tunnelling, but I'd like to keep the config as simple as possible).

TIA

H

149
Views
0
Helpful
0
Replies
CreatePlease to create content