Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Multicast test fails on FWSM

Hi all,

Our customer is trying to test multicast application on FWSM before going to production.

Multicast server and client are connected to one vlan and respective L3 VLAN interface is configured on FWSM.

Multicast is enabled using "Mulicast-routing" command and statically joined IGMP gourp using "IGMP static-group 239.0.10.1"

FWSM is running with 3.1(10)Version.

But the application doesnt work.

can any one suggest what will be the minimum requirement for testing the multicast application in one vlan?

Is there any configuration is required on Switch running with s72033_sp-ADVIPSERVICESK9_WAN-M

Version 12.2(33)SXH4.

Regards

Madhu

1 REPLY
Cisco Employee

Re: Multicast test fails on FWSM

Multicast server and the client are on the same vlan? What is the reason to enable multicast on the FWSM if both the server and the client are on the same vlan?

Multicast on FWSM:

http://www.cisco.com/en/US/docs/security/fwsm/fwsm31/configuration/guide/ip_f.html#wp1041648

Multicast on ASA doc (sender on the outside):

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807631d2.shtml

-KS

204
Views
3
Helpful
1
Replies
CreatePlease to create content