Hi - I am new to Cisco products. We have currently got a Netgear FVX538 running in front of a few servers. We currently have 2 ranges of IP addresses provided to us on 2 separate subnets. We configured the netgear box with the first IP addresses of each subnet as the IP address of each of the primary and secondary LANs. This then allowed us to set the gateway addresses of servers on the network to either of those 2 addresses, depending on it's range.
This all worked fine - except for the fact that the Netgear box is incredibly flakey, so we decided to get a Cisco box.
We have gone for the SA520, which I have been trying to configure this afternoon. Unfortunately I am now having concerns as to whether it is possible to configure 2 separate subnets internally on this box in the same way we have done with the netgear box. If I am right and this is not possible, does anyone know if there is a way of achieving what we want? ie - classical routing, one incoming WAN interface with multiple subnets?
Thanks for getting back to me Julio. I'm not sure whether this helps or not. I'll try and explain the current setup a bit better:
(IP addresses have been changed)
WAN IP : 18.104.22.168
WAN SUBNET : 255.255.255.252
Gateway : 22.214.171.124
Primary LAN : 126.96.36.199
Primary LAN Subnet : 255.255.255.248
Secondary LAN : 188.8.131.52
Secondary LAN Subnet : 255.255.255.248
I can then configure servers on the network on the following ranges:
184.108.40.206 - 220.127.116.11
18.104.22.168 - 22.214.171.124
I can configure the new Cisco box with one of these ranges, but as it doesn't seem to have LAN Multi-homing, I don't seem to be able to add the 2nd subnet. Is this right? Is there another way of configuring it?
Hi - yes, I'd tried that. For example I'd created 2 extra VLANS, so there were VLANS on the following subnets:
I turned DHCP off on all of them. When I was connected to the default 192.168.75.1 VLAN I was able to ping all of the other subnets, ie 192.168.75.1, 192.168.2.1 and 192.168.3.1. When I tried to configure my machine to use one of the other subnets this didn't work.
So if I set up my machine with an ip address of 192.168.2.100 / netmask 255.255.255.0 with a gateway of 192.168.2.1, I wasn't able to ping anything.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...