Hi, I am running v8 of the PIX software with the following config:
inside interface - sec level 100
outside1 interface sec level 0
outside2 interface sec level 2
My question is this, if I have a single nat exemption statement i.e. 'nat (inside) 0' and 2 outside interfaces should the nat exemtion statement work for traffic destined for both interfaces?
I currently have several IPSEC VPN tunnels configured, and I have switched one of the tunnels over to use the outside2 interface with a new IP address. The tunnel comes up, the remote users can connect in to my network fine, however, I can't connect to the remote users. Packet tracer in ASDM shows that my traffic matches the NAT exempt statement and it shows the traffic as going from inside to outside1 and not to outside2.
The remote end has no restrictions on the VPN tunnel.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...