I have set up a small WAN between a Pix/ASA > 3550 > 2 x 2620's (see jpeg of WAN)
The LAN on the Pix where I am is on 192.168.3.0/24 and it can ping the remote WAN site PC (actually the loopback 0 of 2620) on 10.100.0.61.
Now I want to pretend that 192.168.3.0 (my LAN) is already used at this remote site (as if it is a different company and cant change the LAN IP scope) and NAT our LAN range of 192.168.3.0/24 to say 192.168.100.x/24, how can I do this as I'm sure it is a common dilema, I would like to get the Pix to NAT.
Also if 192.168.3.0 gets translated to 192.168.100.0/24 I guess the remote router would need to get this RIP update so would I add the network 192.168.100.0 to the RIPv2 on the PIX?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...