Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

nat (interface) 0 access-list 100 command erase automatically after reboot

I have used nat0 command to transfer outside ip address directly to inside users.But whenever my pix reboots

nat (Interface) access-list 100 command erase automatically& i will have to reconfigure it every time by changing access list name .Please guide me to resolve it permentaly.

7 REPLIES
Cisco Employee

Re: nat (interface) 0 access-list 100 command erase automaticall

you make this configuration via ASDM ? are those host/network being named ?

what version you running ?

New Member

Re: nat (interface) 0 access-list 100 command erase automaticall

hi ..

i did it by console..version 7.1 is used.i didnt get your 2nd point.

sample config...

# nat (inside) 0 access-list 100

# access-list 100 permit ip any 145.xx.xx.xx

Thanks...

Cisco Employee

Re: nat (interface) 0 access-list 100 command erase automaticall

looks like a bug to me..is upgrade possible for you ?

Silver

Re: nat (interface) 0 access-list 100 command erase automaticall

That's the price you pay for running Early

Deployment (ED) code. These are 'beta' code

as far as I am concerned.

The question is: is downgrade possible for you?

You should be running 7.0(7) because it is

General Deployment (GD) code.

CCIE Security

Cisco Employee

Re: nat (interface) 0 access-list 100 command erase automaticall

I would suggest for an upgrade to 7.2.3 which is quite stable and was an end to all the 7.2.x interims.

Silver

Re: nat (interface) 0 access-list 100 command erase automaticall

Is version 7.2(3) ED or GD?

I would STRONGLY recommed staying from any

ED code. They are just not stable.

my 2c.

Cisco Employee

Re: nat (interface) 0 access-list 100 command erase automaticall

hello Requester..7.0.3 doesn't support many features like U-turning of clear text traffic,PPOE,and many other...you are safe to to go 7.2.3 as this was a dead end for all interims on 7.2.x and has been quite stable...if you want to go to 7.0.7 (GD) you will loose many feature set..choice is yours.

124
Views
0
Helpful
7
Replies
CreatePlease to create content