Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

nat or no nat

I don't think I'll need nat enabled, but wanted to double check:

My ASA that I'm configuring is behind another device that actually NATs the traffic for us. I have a public address assigned to my outside interface on the ASA and a private on the inside. I believe I can use "no nat-control", but I think I'll still need to use static commands to redirect the traffic.

Does this sound right?

Thanks,

John

HTH, John *** Please rate all useful posts ***
1 REPLY
Gold

Re: nat or no nat

can you elaborate on this, "but I think I'll still need to use static commands to redirect the traffic. "?

Make sure the device that is actually NAT'ing for you, has the proper routing table entries pointing to the ASA to get back to the 'private' network address space.

236
Views
0
Helpful
1
Replies