Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)

Nat over site-to-site vpn

All,

I have a need to create a vpn tunnel with a vendor. They want me to pass my actual public address through the tunnel because they don't allow private addressing over their tunnels. I don't have nat configured on my ASA now as it is. How would I even go about setting this up because I've never done one of these before. They said that I could nat my private network using the same address that I've specified as my peer. Any ideas?

Thanks,

John

HTH, John *** Please rate all useful posts ***
1 REPLY

Re: Nat over site-to-site vpn

John-

Check this configuration example. Do note the Introduction as it covers some of the limitations of NAT over a VPN tunnel.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00808c9950.shtml

279
Views
5
Helpful
1
Replies
CreatePlease to create content