access-list NONAT permit ip 10.0.0.0 255.0.0.0 172.16.0.0 255.255.0.0
I did above config in PIX to only allow telnet traffic inside my network and DMZ from outside now outside to inside telnet possible with first host suppose 126.96.36.199 .... unfortunately DMZ to outside work but outside to DMZ 188.8.131.52 not telnetting ???????!!!!!!!!!!!
Please help me why outside to DMZ not telnet even though DMZ to outside telnet and outside also get global address 184.108.40.206 !!!!
inside --->outside 10.1.1.2 --- 220.127.116.11 (after NAT) telnet-------> 18.104.22.168 good
dmz----->outside 172.16.1.2 ---- 22.214.171.124(after NAT) telnet ------>126.96.36.199 good again
outside ---->dmz 188.8.131.52----184.108.40.206 telnet bad
Thanks in advance I attached my lab and config with this mail.
Thanks but in INSIDE to OUTSIDE also higher to lower in that NAT is working fine sometime I use """GLOBAL(OUTSIDE) 1 interface"""" ...command also and that also worked ,so why for DMZ not working ...I guess I used 2 NAT that is why
nat (inside) 1 0 0
nat (inside) 2 0.0
But I removed nat (inside) 1 0 0 and after that also it was not working only after static it is working confusion
Telnet is working just fine from DMZ to OUTSIDE(220.127.116.11) and traslating also but my question is why outside can not telnet to my DMZ ?????? and one more thing outside can telnet to inside so it is working !!!!
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...