Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nat single inside host to public IP.

Good day all,

im sure that this questing has bin asked many times. but i can't figure this this out.

one of my customers has a mail server. i have nat and firewall rules that permits smtp/https access on 1 of there public ip adresses.

now we need reverse dns for mail security so I want that all traffic the is sending from inside host 192.168.169.100 to be send out with a different public ip then that is used by the dynamic nat rule for the rest of the network.

the ASA uses SW level 8.04

can some one help me with this.

thanks in advance.

Yoeri

Everyone's tags (4)
2 REPLIES

Nat single inside host to public IP.

You will need to use static NAT, so a 1:1 NAT between 192.168.169.100:

check this URL:  http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/nat_static.html

hope it helps

Please remember to rate useful posts, by clicking on the stars below.

New Member

Nat single inside host to public IP.

thanks for response Minkdennis,

so if i understand correctly I'll get a NAT rule that is something like.

static (inside,outside) 1.1.1.2 192.168.169.100 netmask 255.255.255.255.

i have also some statics for smtp and https, do i need to remove them?

thanks  Yoeri

481
Views
0
Helpful
2
Replies
CreatePlease to create content