When inside hosts are subjected to NAT on the firewall, the firewall will first try to exhaust the one-to-one mapping specified by your range of global IPs. Only when a fourth inside host attempts a connection outbound will the firewall create a PAT translation. You said you had three inside PCs, and that would account for why the PAT entry is not being used.
Basically, the firewall only uses the dynamic PAT ips if it must, and tries to use the static nat entries if there are some free.
ishesh kumar do you have only 3 host in the inside. If that so you do not need the PAT because every host has an ip available the PAT in this case is gonna work when the pool is full. Just like Jay said
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...