When I checked its looks like PIX doesnt take the command, in "sh run" only shows one entry.So the second entry has not taken.
I could use
access-list policy_nat_rdp1 permit ip host 10.10.10.1 any
access-list policy_nat_rdp2 permit ip host 10.10.10.1 any
But with out "extended" portion. It accepted`both lines.
But "static (inside,outside) 188.8.131.52 access-list policy_nat_rdp1" was the problem. It doesnt take "policy_nat_rdp1". The syntax only allow IP addresses it seems it says "ERROR: Invalid global IP address access-list".
I really appriciate your Help on this. Thanks again.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...