Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Need Remote access for support

I am trying setup up remote access to be able to support PIX and ASA units I have vpn working but I am not sure how to configure the remote access and PDM

2 REPLIES
Gold

Re: Need Remote access for support

make sure the inside IP address of the appliance is part of the crypto ACL. make sure the 'management-access inside' command is configured as well.

then make sure you've configured telnet and http access to the device from the address pool used for remote vpn access.

New Member

Re: Need Remote access for support

For ASDM/HTTPS

Go to configuration -> Device Management -> ASDM/HTTPS -> Add the IP address of the host ip that is going to get in to your box. Specify the interface in this case if they are outside your network, it will be the outside interface.

Same thing you have to do for SSH and telnet but I don't recommend using telnet since it sends data in clear text.

129
Views
8
Helpful
2
Replies
CreatePlease to create content