Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need telnet access without NAT

I have an issue with ASA 5510 Firewall.I have three interfaces X,Y and Z, where X has a security level of 0, Y=0 and Z=10.

I need to access hosts on Y from Z.As of now it works fine with NAT.All i want is to access hosts with no NATing.

I have applied an access list to permit telnet and able to see the hit counts

,but i see only a black screen.I tried changing the security levels and applying same-security-interface command,but didnt work.

Is there anything else which you would like to tell us on this issue.

Any help would be appreciated.

Regards,

Vijay

3 REPLIES

Re: Need telnet access without NAT

Vijay,

Try adding the following to your nat config:-

static (Z,Y) z.z.z.z y.y.y.y netmask x.x.x.x

or you could create a policy based no-nat....but try the above first.

HTH>

New Member

Re: Need telnet access without NAT

Hello Andrew

The issue was with Internal routing.I added a route and it started working fine.

Thanks for your reply.

Regards,

vijay

Re: Need telnet access without NAT

np - glad to help.

113
Views
0
Helpful
3
Replies