Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need to add second IP to outside interface of ASA 5520

Here is my scenario. 

We have a block of addresses assigned to us by our ISP.  We need to assign one of these addresses to a vendor we use for traffic to one of their internal devices.  Lets say the address we gave them out of that block of addresses is 1.2.3.4

How do I add that address to the outside interface so that when traffic s sent to it that the traffic actually gets to the ASA as right now when we send traffic to that address it doean't make it to the ASA.

Sorry if I may be asking a dumb question.  Sometimes I do not see the obvious.

Sincerely

Paul

1 REPLY
New Member

Need to add second IP to outside interface of ASA 5520

As long as that block of IPs is being routed to your ASA all you should need to do is create a static NAT entry to translate the public IP to the internal IP of the vendor device.

668
Views
0
Helpful
1
Replies