I have 2 asa 5550's v8.2 in an active/standby config, our secondary failed and we have a new RMA unit from cisco. After MUCH stress from tac getting the right feature set on it I am taking another stab tomorrow morning using the following procedure.
Commands on primary
failover (is currently disabled)
Commands on secodary
failover lan interface fail g1/0
failover interface ip fail 192.168.25.2 255.255.255.248 standby 192.168.25.2
int g1/0 no shut
failover lan unit secondary
copy run start
Question, in v8.2 do I need to run a "write standby"?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...