I have a couple of PIX 506E firewalls, and am trying to figure out how to configure them for my network. I'm tryin to use PDM 3.0, because my command line abilities aren't good yet, but I'm learning. I'm trying to figure out two specific things. 1) How to port forward certain traffic (smtp, terminal services, etc)to an internal server with a static IP. Do you do this through access rules in PDM?
2) I want to set up the 2nd 506E in our remote office and have VPN between them. Is there a guide somewhere to set this type of thing up? I'm searching Cisco's site, but haven't found anything yet.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...