Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

No Response From ASA5510

We have an ASA5510 and I am getting absolutely no response from the console port.  Not even a blip when I turn it on.  If I leave the compact flash in the internal bay, I get Green Power, Amber Status, Amber Active and Green VPN when I start it up.  The Flash LED flashes Green twice then goes out.  If I move the compact flash to the external bay, all of the other lights remain the same as described above but the Flash LED goes to steady Green.  However, there is still no response whatsoever from the console port.  Have replaced the DIMM but that had no effect.  This is a four (4) slot ASA5510 and I have just the one DIMM in slot P13 as described on a post I found.  The power supply fan comes on as well as the two (2) fans that cool the heatsink.  The other two (2) fans on the expansion module side do not come on.  To paraphrase Bones, "Is It Dead, Jim?"

1 REPLY
Cisco Employee

No Response From ASA5510

Good quote and yes, total abnormal behavior. If the console does not respond, it is gone by far.

Mike.

Mike
449
Views
0
Helpful
1
Replies
CreatePlease to create content