08-21-2013 01:08 PM - edited 03-11-2019 07:29 PM
I HAVE asa5545 , i shutdown the ips , and unintsall the ips software module, and reload the asa, account to 9.1 configure cli guide, and upload the asa cx boot image, and reboot the cx module, wait 5 min, session cx console, i see the
# session cxsc console
Opening console session with module cxsc.
Connected to module cxsc. Escape character sequence is 'CTRL-^X'.
but there is no user/password prompt
i am expectiong the prompt to login . the session is just blank
I exist to ASA, and show module, it still show the cx module recover .
i tried many time, even reboot the ASA, Still can not see the user login prompt in the cx console ?
anyone know this problem ?
when I show the module,
isee
Mod Card Type Model Serial No.
---- -------------------------------------------- ------------------ -----------
0 ASA 5545-X with SW, 8 GE Data, 1 GE Mgmt ASA5545 FCH1705J14G
ips Unknown N/A FCH1705J14G
cxsc Unknown N/A FCH1705J14G
Mod MAC Address Range Hw Version Fw Version Sw Version
---- --------------------------------- ------------ ------------ ---------------
0 b0fa.eb97.b9f5 to b0fa.eb97.b9fe 1.0 2.1(9)8 9.1(2)
ips b0fa.eb97.b9f3 to b0fa.eb97.b9f3 N/A N/A
cxsc b0fa.eb97.b9f3 to b0fa.eb97.b9f3 N/A N/A
Mod SSM Application Name Status SSM Application Version
---- ------------------------------ ---------------- --------------------------
ips Unknown No Image Present Not Applicable
Mod Status Data Plane Status Compatibility
---- ------------------ --------------------- -------------
0 Up Sys Not Applicable
ips Unresponsive Not Applicable
cxsc Recover Not Applicable
08-21-2013 04:14 PM
Hmm. Yes the recover status plus lack of login prompt indicates the CXSC module has not completed its boot.
Did you use the commands:
sw-module module cxsc recover configure image disk0:/asacx-5500x-boot-9.1.2-21.img
(or later image version - however it is important that you use the boot image first to bootstrap)
sw-module module cxsc recover boot
If you didn't, then I would try to shutdown, uninstall and re-try using those commands in addition to an uninstall (first) as follows:
sw-module module cxsc shutdown
(wait until show module indicates it is shutdown)
sw-module module cxsc uninstall
03-10-2014 08:46 AM
I am having the same issue. HOwever, when I try the commands above, it does not seem to help. When I issue the uninstall command, it returns a message indicating that there is no software available to uninstall. Also, when I look at the logs, it shows the correct version and appears to be waiting at a login prompt of sorts.
Any further input would be greatly appreciated.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide