I have a PIX that I would like to say has stopped passing traffic but that would not be exactly correct. I have not been able to get to any address that is set up as a statically translated through my PIX. From the internal network everything is working but from the outside I am completely down. I can get to the boarder router and the PIX (my vpn runs off the PIX and I can vpn in by IP) but I can not get to any of my web sites or DNS servers or anything else. I checked the ACL and I see hits on it but nothing is making full connections. I did a capture on my outside int and see a ton of DNS traffic but not much else. I tried debugging and I am not seeing any of that traffic either. I have tried rebooting my boarder router, I have tried rebooting my PIX I have verified that the PIX can see the servers on the inside and I know that it is passing traffic as I can get to the outside and VPN in. Any other suggestions would be greatly appreciated.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...