I have some home managed to break my outgoing VPN connections. We connect to a clients site via Cisco VPN and I originaly got it to work by createing a Dynamic NAT statment NATTIng to .120-.124 of our public IP addresses. Somehow I have managed to break this and can't figure out how to fix it again. I have attached my sanitized config for help.
If you have added some lines in configuration or removed them, then restore them back to the original. The error message that you get when connecting VPN will help. You can use tool "error message decoder" on cisco.com to get to the problem.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...