Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Outside unable to access inside server

we have a direct connection to another agency from an interface on our 5520 to their firewall. a user on their side needs access to a server on our inside network. We have an IP ANY ANY access rule for this interface. I've created a static NAT for the server they need to connect to and gave them the NATed address. They tried and said it isn't working. Do I need to add a route for their IP to my inside network? Is there a good way to troubleshoot this issue? I haven't used captures enough to really know how to analyze what I'm seeing.

2 REPLIES
Green

Re: Outside unable to access inside server

Could you post the relevant parts of the config?

New Member

Re: Outside unable to access inside server

Thanks for looking at this. I'm not sure about the security here (first time here) so I XX'd out the IPs.

I was told the IP's for their PCs are NATed to 192.x.x.x

Interface is UP

IP address 172.x.x.x, subnet mask 255.255.255.0

access-list place line 1 extended permit ip any any (hitcnt=146)

static (inside,place) 172.x.x.x 10.x.x.x netmask 255.255.255.255

108
Views
0
Helpful
2
Replies