Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Overlapping IP address ranges on VPN

I need to create a new site to site VPN where the address range on the new site is 10.1.0.0/24. The problem is that I already have this same range on a WAN connection, which the Pix knows about due to the "route inside" statement. I don't believ that the alias command will work in this scenario. Does anybody have any ideas how this can be done?

1 REPLY
Hall of Fame Super Blue

Re: Overlapping IP address ranges on VPN

You could NAT the 10.1.0.0/24 IP addresses before they enter the VPN at the remote end.

If the traffic is only ever intiated from the new site you could hide all the 10.1.0.0/24 addresses behind one IP address which would need to be routable back to the new site.

If traffic needs to be initiated both ways then you'll need to set up one to one translations for the 10.1.0.0/24 addresses. Again the translated addresses used would need to be routable back to the new site.

Here's a link to a Cisco doc on Overlapping Networks

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a0080093f30.shtml

HTH

270
Views
0
Helpful
1
Replies