Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Overlapping subnet VPN and static nat

Hi,

IPSec tunnel is running between 2 sites.Now we need to configure static NAT for 1 IP address comes under overlapping subnet.

When we configure static nat then whole traffic is transfered to the static nat connection and my tunnel see not traffic.

Any idea how to solve this problem.We need:

1. IPSec tunnel should work under overlapping n/w

2. static will also work

We could not able to do any config changes at the other site os the tunnel .

1 REPLY

Re: Overlapping subnet VPN and static nat

Hi Vikas

you can use policy nat like following

lets say that if x.x.x.x in inside wants to reach y.y.y.y, it will be translated(static nat) to z.z.z.z on outside interface

access-list policy-nat permit ip x.x.x.x 255.255.255.255 y.y.y.y 255.255.255.255

static (inside,outside) z.z.z.z access-list policy-nat

Regards

144
Views
0
Helpful
1
Replies
CreatePlease to create content