Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pıx's telnet problem

ı didn't connect pıx clı.It always give error about telnet problem.What is the source in this problem.

3 REPLIES

Re: Pıx's telnet problem

Would you please tell us the error log you have? You want to connect to PIX via telnet?

New Member

Re: Pıx's telnet problem

you need to tell the pix which hosts/networks are allowed to telnet to the pix. for example if you want just your ip address to telnet, and your ip is 192.168.1.100 you issue "telnet 192.168.1.100 255.255.255.255 inside" If you are running version 7.0+ you also need "management-access inside"

New Member

Re: Pıx's telnet problem

I would not configure telnet, but ssh for remote access. The above post is also on point. You can do that with ssh.

104
Views
0
Helpful
3
Replies