Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

P2P VPN problem

I have a Pix 515 at one site that I need to set up with P2P VPN access to another site. My problem is that the outside interface of the Pix is not an external IP address. The border router that I have at the location has two separate internet T1s coming into it from two separate ISPs. So connection between the border router and the Pix is a 172.16.x.x/30 and we route all traffic down that, then we use route mapping to force specific traffic down one of the internet pipes based on the source IP (using NAT).

Since the firewall's ouside interface is a 172.16.x.x/30 address instead of a real world external IP how do I set it up for the P2P VPN?

1 REPLY
Silver

Re: P2P VPN problem

Hi

You will have to configure static NAT on the gateway router. Have a look at the following doc:

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080094ecd.shtml

Thanks

John

98
Views
0
Helpful
1
Replies