I was looking for some commands to do a packet capture with Cisco PIX and ASA firewalls. I am familiar with the Juniper Netscreen debug commands but really never tried on a Cisco device.
What commands does Cisco use to see real time packet captures for traffic that is allowed and/or denied? With the junipers I can specify src and dst and even a port and it will tell me what Policy its passing on. Does Cisco packet capture have the same granularity?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...