Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Packet drop on FWSM L3 interface.

Hi,

My FWSM cpu/memory utilization is quite normal, but when i checked the the VLAN interfaces configured on FWSM , i find lots of packet drop.

There are more then 20 VLAN interface defined in FWSM. I am suspecting high load between FWSM and switch through etherchannel port-channel which automatically configured when we install FWSM in switch, but dont the command to verify the actual load . can some1 help in solving this issue.

Thanks & regards

madhu

1 REPLY
Cisco Employee

Re: Packet drop on FWSM L3 interface.

On the FWSM:

clear traffic

sh traffic

sh np blocks (couple of times to see if the counter increments)

On the switch:

show int po 270 counters etherchannel

where 270 is from the output of the command "sh etherchannel sum" the etherchannel that the FWSM creates with the switch on the back end.

-KS

793
Views
0
Helpful
1
Replies
CreatePlease login to create content