10-16-2014 04:38 PM - edited 03-11-2019 09:57 PM
Hi;
How can I configure the PAT on my 5512 to allow smtp traffic coming from the internet? I have one public ip only, but I need direct the smtp, http traffic to two different server internal.
Solved! Go to Solution.
10-17-2014 03:52 AM
Hi,
It should be simple like this:-
Server 1 :- Private Ip1
Server 1 :- Private Ip2
Public IP
object network obj-Server1
host Private Ip1
nat (inside,outside) static Public IP service tcp smtp smtp
object network obj-Server2
host Private Ip2
nat (inside,outside) static Public IP service tcp http http
Also , remember to allow these ports in the ACL on the outside incoming traffic ACL.
Something like this:-
access-list Out-IN permit tcp any host Private Ip1 eq smtp
Thanks and Regards,
Vibhor Amrodia
10-17-2014 03:52 AM
Hi,
It should be simple like this:-
Server 1 :- Private Ip1
Server 1 :- Private Ip2
Public IP
object network obj-Server1
host Private Ip1
nat (inside,outside) static Public IP service tcp smtp smtp
object network obj-Server2
host Private Ip2
nat (inside,outside) static Public IP service tcp http http
Also , remember to allow these ports in the ACL on the outside incoming traffic ACL.
Something like this:-
access-list Out-IN permit tcp any host Private Ip1 eq smtp
Thanks and Regards,
Vibhor Amrodia
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: