Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

PAT not working

Hi All,

Simple problem i have setup a NAT Rule as follows

static (Inside,Outside) tcp WEB_REMOTE_ACCESS_EXT 2081 JENKINS https netmask 255.255.255.255 

It wont let me use port 2081 to get to that server if i change it to 443 it works fine. I have tried changing it to various custom ports but no help

Any ideas as i dont think there is much more i need to configure to get it working

Hope you can help

Marco

Everyone's tags (3)
1 REPLY

PAT not working

Hello Marco,

Is the traffic reaching the  WEB_REMOTE_ACCESS_EXT on port 2081, are you seeing the packets reaching the ASA???


Have you place the ACL pointing to that IP address on port 2081

Regards,


Julio

Cisco Security Engineer

Please rate all the helpful posts

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
275
Views
0
Helpful
1
Replies
CreatePlease to create content