07-02-2007 11:10 AM - edited 03-11-2019 03:38 AM
What are the steps to follow when turning on logging on in the PDM for viewing debugging in the console window
Solved! Go to Solution.
07-02-2007 04:32 PM
Hey ..
Here are the steps to enable console logging from PDM 3.x:
Enable console logging-
Configuration ->> System Properties ->> Logging ->> Others
Here you'll see "Send syslog messages to your PIX console. Configure this
only if you are doing troubleshooting."
Here you can choose the level of syslogs you need to see on console screen.
Next, you need to enable logging, you can do so from-
Configuration ->> System Properties ->> Logging ->> Logging Setup
Make sure you have the check box checked for "Enable Logging"
That's it, now you should be able to see syslogs at console screen.
However, make sure that you are doing so only for troubleshooting as
logging on console could be CPU intensive.
Hope this helps.
Regards,
Vibhor.
07-02-2007 04:32 PM
Hey ..
Here are the steps to enable console logging from PDM 3.x:
Enable console logging-
Configuration ->> System Properties ->> Logging ->> Others
Here you'll see "Send syslog messages to your PIX console. Configure this
only if you are doing troubleshooting."
Here you can choose the level of syslogs you need to see on console screen.
Next, you need to enable logging, you can do so from-
Configuration ->> System Properties ->> Logging ->> Logging Setup
Make sure you have the check box checked for "Enable Logging"
That's it, now you should be able to see syslogs at console screen.
However, make sure that you are doing so only for troubleshooting as
logging on console could be CPU intensive.
Hope this helps.
Regards,
Vibhor.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: