Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

PDM error

Hello, I have installed a FWSM 2.3(4) and when I change a policy for example and I intend to save the config, the PDM shows this error:

"PDM received an error when one or more of the commands below were sent to the FWSM."

Someone could help me please?

Thank you and sorry for my bad English.

Regards

2 REPLIES
Silver

Re: PDM error

Run the same commands you tried sending through the PDM on the CLI. See what error comes out. Usually should do something with the wrong config statement.

Hoogen

New Member

Re: PDM error

Thank you hoogen_82. The problem is that this error is showed in many times, that is, every time that I save the config. Moreover, I think that this problem is generated other problem, since my modules are working with failover and I think that the config isn't copied to the standby module.

Could you help me please?

Thank you for all.

Regards.

186
Views
0
Helpful
2
Replies
CreatePlease to create content