Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PDM Installation

I have a ASA5510 that I performed a write erase on now my PDM does not work even after running the setup from the CLI. Do I need to reinstall or TFTP the PDM back on the ASA?

1 REPLY

Re: PDM Installation

Hello,

The PDM will remain the software, even if you write erase or reboot.. since u have written off all the configs, the http access to your ASA would have been lost... you need to re-enable the http access to your ASA using the "http enable" command.. also go to the console and check for the IP addresses on the interfaces...

hope this helps.. all the best..

RAj

110
Views
0
Helpful
1
Replies