Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Permit ALL

Hi!

How to permit ALL on my PIX501 fw?

BR

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Permit ALL

You need to open the ACL, only if there is one on the inside high security interface.

If you are pinging from an inside host you will not be able to ping the outside interafec of the ASA, only the inside.

For being able to ping outside hosts check your natting on the firewall. You need to translate the inside host in such a way that the outside host has a route back.

I hope it helps.

PK

3 REPLIES
Cisco Employee

Re: Permit ALL

Details are lacking on this question. To create an ACL that permits all traffic:

access-list myacl permit ip any any

-heather

Community Member

Re: Permit ALL

I am asking because I cannot ping my outside interface and any other outside ip.

Cisco Employee

Re: Permit ALL

You need to open the ACL, only if there is one on the inside high security interface.

If you are pinging from an inside host you will not be able to ping the outside interafec of the ASA, only the inside.

For being able to ping outside hosts check your natting on the firewall. You need to translate the inside host in such a way that the outside host has a route back.

I hope it helps.

PK

129
Views
0
Helpful
3
Replies
CreatePlease to create content