Re: PIX-1FE card compatible for both 520 and 515E?
I doubt that Cisco would support any after-market ethernet card in a PIX; then again, if you have no warranty or maintenence contract, it would be a moot point.
Your best bet for finding out would be to look up the FCC code on the card and match up other manufacturers that use the same chipset. Otherwise, sticking with a Cisco card is the only way to remain compatible with the NIC drivers that are likely firmware-based in the PIX and not changeable.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...