Hi. I have at a remote location a PIX 501 that also acts as DHCP server for that network. There will be some changes in the network and I should change the IP's of the DNS servers that are sent to hosts.
Is it enough that I issue the no version of the dhcpd dns x.x.x.x y.y.y.y command an then enter new addresses for hosts to acquire the new DNS server IP's or should I also do something else?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...