Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX 501 Config not saving

PIX 501 Config not saving

I have tried over and over and over again reseting back to default and it will not save the default. any ideas?

3 REPLIES

Re: PIX 501 Config not saving

Are you trying to reset the config to default@factory default with basic config?

Try 'write erase' and confirm yes 'y'. Reboot the box - it will boot with factory basic config.

Hope this helps. Pls rate useful post(s).

AK

Re: PIX 501 Config not saving

Factory reset looks like:

interface ethernet0 auto shutdown

interface ethernet1 auto

interface ethernet2 auto shutdown

nameif ethernet0 outside security0

nameif ethernet1 inside security100

nameif ethernet2 intf2 security4

enable password xxx

passwd xxx

hostname pixfirewall

fixup protocol dns maximum-length 512

fixup protocol ftp 21

fixup protocol h323 h225 1720

fixup protocol h323 ras 1718-1719

fixup protocol http 80

fixup protocol rsh 514

fixup protocol rtsp 554

fixup protocol sip 5060

fixup protocol sip udp 5060

fixup protocol skinny 2000

fixup protocol smtp 25

fixup protocol sqlnet 1521

fixup protocol tftp 69

names

pager lines 24

mtu outside 1500

mtu inside 1500

mtu intf2 1500

no ip address outside

ip address inside 192.168.1.1 255.255.255.0

no ip address intf2

ip audit info action alarm

ip audit attack action alarm

pdm logging informational 100

pdm history enable

arp timeout 14400

timeout xlate 3:00:00

timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 rpc 0:10:00 h225 1:00:00

timeout h323 0:05:00 mgcp 0:05:00 sip 0:30:00 sip_media 0:02:00

timeout uauth 0:05:00 absolute

aaa-server TACACS+ protocol tacacs+

aaa-server TACACS+ max-failed-attempts 3

aaa-server TACACS+ deadtime 10

aaa-server RADIUS protocol radius

aaa-server RADIUS max-failed-attempts 3

aaa-server RADIUS deadtime 10

aaa-server LOCAL protocol local

http server enable

http 192.168.1.0 255.255.255.0 inside

no snmp-server location

no snmp-server contact

snmp-server community public

no snmp-server enable traps

floodguard enable

telnet timeout 5

ssh timeout 5

console timeout 0

dhcpd address 192.168.1.2-192.168.1.254 inside

dhcpd lease 3600

dhcpd ping_timeout 750

dhcpd auto_config outside

dhcpd enable inside

terminal width 80

But the POST before should give the same results.

New Member

Re: PIX 501 Config not saving

Try removing your dhcpd config with the NO command " No dhcpd enable" etc then do the wr erase.

I can not tell which Version IOS but also clear configure all then wr erase.

Bill Harrison

Cisco Instructor

259
Views
0
Helpful
3
Replies