Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix 501 confige but not working

I have bsnl router

pix outside 192.168.1.101 255.255.255.0

inside 192.168.10.1 255.255.255.0

lan network ip address range 192.168.10.101 - 192.168.10.250

pix configuration with command prompt

Pix CONFIGURATION

1) Enable

2) Hostname

3) Interface e0 auto I

4) nterface e1 100full

5) Nameif e0 outside security 0

6) Nameif e1 inside security 100

7) ip address inside 192.168.10.1 255.255.255.0

8) ip address outside 192.168.1.101 255.255.255.0

9) nat (inside) 1 0.0.0.0 0.0.0.0 0 0

10) global(outside) 1 192.168.1.111-192.168.1.150 netmask 255.255.255.0

11) route outside 0.0.0.0 0.0.0.0 192.168.1.100 1

12)

when I insert pix into live network internet not working on any computer

I ping to my computer to inside ip address ,it is pinging

pl modify any changes and send to me

MY Email-ID dinchavan11@yahoo.com

contact nubmer 9860051380

1 REPLY

Re: pix 501 confige but not working

Hi dinesh

When a computer is directly connected to BSNL and has a gateway of 192.168.1.100, can it connect to internet?

Also make sure interfaces are up

int eth0

no shu

int eth1

no shu

Can you please post the running-config of both devices? (type sh run to see config in user mode)

Regards

169
Views
0
Helpful
1
Replies
CreatePlease login to create content