Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX 501 configuration with Cable modem

How do you configure the outside interface to receive its IP address from a dhcp server? (in this case, from a cable modem)

I have a 501 PIX running 6.3.5

Also, after you configure the outside interface for dhcp, how do yu configure the route so everyone on the inside can see the internet?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: PIX 501 configuration with Cable modem

Version 6.x:

ip address outside dhcp setroute

Remove any default gateways from your config.

7.x/8.x:

int eth0/x

ip address dhcp setroute

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806c1cd5.shtml#client

Please rate if helpful

Regards

Farrukh

2 REPLIES

Re: PIX 501 configuration with Cable modem

Version 6.x:

ip address outside dhcp setroute

Remove any default gateways from your config.

7.x/8.x:

int eth0/x

ip address dhcp setroute

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806c1cd5.shtml#client

Please rate if helpful

Regards

Farrukh

New Member

Re: PIX 501 configuration with Cable modem

It worked!!....

I don't know why the route statement has to be ommited, but works...

thank you very Farrukh

244
Views
0
Helpful
2
Replies