Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix 501 configure for Bloomberg

Hello,

I have a pix501 and want to configure a routing for bloomberg router. But the pix501 does not have enough interface for the configuration. we don't have spare router or layer3 switch. Any suggests?

thanks.

6 REPLIES

Re: pix 501 configure for Bloomberg

Hi Alex

Pix 501 firewall comes with 2 interfaces inside,outside interface on which you dont have the facility of configuring vlans even..

But do revert back what kinda config or what you are trying to do over here.

regds

New Member

Re: pix 501 configure for Bloomberg

for a private connection to bloomberg, all hosts must be able to connect to the following bloomberg subnets:

208.134.161.0/24

205.183.246.0/24

...etc.

how can pix501 configure to route statically to the above prefixes through the ethernet port of the bloomberg access router.

Re: pix 501 configure for Bloomberg

Hi Alex

Can you post a diagram representing the setup and what you exactly want to route ..

regds

New Member

Re: pix 501 configure for Bloomberg

Hi Spremkumar,

Suppose the bloomberg router should be connected to one of interface in firewall, but no spare interface in the pix501 firewall now.

Re: pix 501 configure for Bloomberg

Hi Alex

I got your requirement now but since theres no other port available you wont be able to plugin the router directly onto the firewall.

You may need to upgrade the firewall to the next possible version (506E)which can afford or allow you to create logical interfaces...

BTW whats your exact requirement with two links out there ? vpn or internet access ??

regds

New Member

Re: pix 501 configure for Bloomberg

bloomberg will use a their own link so that if the Internet goes down, bloomberg still works unless their link is down.

264
Views
0
Helpful
6
Replies
CreatePlease login to create content