Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 501 login

I have a Pix 501 firewall. I can use putty and login. My Pc's are connecting by receiving ip addresses. I am wanting to connect using browser to do some additional setup. It used to work at Please look at the config and tell me where I am missing.


Thank you

VIP Green

Make sure that the ASDM is

Make sure that the ASDM is located on the flash by issuing the dir command

locate the ASDM image file name (if it is not there you will need to copy it into flash)

then highlight and copy the whole filename (it will look something like this: asdm613.bin)

Then add the following command to your pix

asdm image flash:/asdm613.bin

remember to replace asdm613.bin with your actual asdm file name.


Please remember to select a correct answer and rate helpful posts



Please remember to rate and select a correct answer
VIP Purple

For the PIX501, you need a

For the PIX501, you need a PDM-image and not an ASDM-image. Hopefully you still have it in flash, it seems that it's not available anymore at Here is a link for troubleshooting the PDM:

Don't stop after you've improved your network! Improve the world by lending money to the working poor:
CreatePlease login to create content