After a power cycle our pix quit passing traffic from clients being the firewall to the internet though nothing had changed. I can ping addresses from the pix CLI, but not from any workstation. I have reset the 501 back to factory default and manually reapplied the config. I have also upgraded to 6.3(5), but no luck. Here is my config, any help would be appreciated.
I am not sure about ICMP inspection, but when I try and connect to the web on a client I get page cannot be displayed. I cannot get DNS resolution either from our public DNS server. It seems like every piece of traffic is not being permitted outbound.
If someone could post how to enable logging so I do not have to look it up, that would be great!
Appreciate all your help. I tried debug (which I could not interpret) and logging, but it would not log any information concern http traffic. What I did figure out was that I could hit a site via IP, but not name. So I removed and re-added the fixup protocol DNS. I think that is what ultimately did it. I also added some access-lists to the inside interface, but I ended up removing them.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...