03-19-2012 11:21 AM - edited 03-11-2019 03:44 PM
All,
I have a friend trying to configure an existing PIX. They needed to change IP addresses due to ISP switch. Config was very basic but whenever he puts in the route outside command the PIX seems to take it but then he is saying it is disappearing when he checks the config. Does anyone have any ideas what this could be? He only changed outside IP address, a static translation
All replies rated. Thanks in advance!
03-19-2012 11:56 AM
Hi Angel,
My assumption is that you have a speed issue between the outside interface of the PIX and the new ISP equipment.
You have statically set the outside interface "interface ethernet0 10baset"
Please post :
show int e0
PS : nice software version 6.2
Regards
Dan
03-19-2012 01:48 PM
TUrns out the tech was plugged into the wrong equipment.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: